Enfield Ramrod In Section 1/4" x 39" OUT OF STOCK

As our Enfield ramrods but supplied in sections with the main shaft of 1/4". Sufficient material to allow for a 39" - 3 band rod.
This is mainly for the purpose of avoiding the high shipping cost related to sending long items overseas, as this set can shipped using the standard shipping options.
We use the 'hole and pin' method which allows easier alignment for the builder, however would require welding on the joints for the best results. Brazing can be used but will tend to show a unwanted joint line.
The rod sections can be shortened, however avoid trimming the threaded end if possible, and trim and re-drill a middle section instead.